Discreet Carry Concepts Clips

Description

Brand: Discreet Carry Concepts™
*Clips are sold individually. One each = one clip*

HLR 2.1u

For vertical IWB or Pocket carry

• 2.89″ OAL +/-.03″
• Width: .624″

Designed to be worn on a pocket or behind the belt and out of sight. Nothing to be seen extending below or over the belt.
Standard DMG/Cu finish: Color – DCC dark matte grey. Non reflective and resists corrosion very well.
Hardware included.
Care and maintenance: Our new finish does not need much attention. If any light scratches or wear marks develop, we recommend a quick buff with WD40, but anything from vegetable oil to mineral oil to CLP to motor oil will work well. Just put a couple drops on your clip and rub it in vigorously using firm pressure with a lint free cloth. This will help keep it looking it’s best cosmetically.

Monoblock

For Horizontal (Cross-draw)

Fits ALL T.Kell Sheaths

2.73″ OAL
Fits over belts up to 1.5″
(2) .220″H x .300″W horizontal slotted mounting holes will work with spacing that is .750″ – 1.00″ on center.
Standard DMG/Cu finish: Color – DCC dark matte grey. Non reflective and resists corrosion very well
Works with or without a belt.
Hardware included.

Standard DMG/Cu finish on all components: Color – DCC dark matte grey. Non reflective and resists corrosion very well
The Monoblock is engineered to be mounted directly to the Sheath body or other solid surface. Recommended hardware configuration from top to bottom: Screw, monoblock clip, rubber washer, body of the holster. The nut is placed on the inside.

Care and maintenance: Our surface finish does not need much attention. If any light scratches or wear marks develop, we recommend a quick yet firm buff with WD40, but anything from vegetable oil to mineral oil to CLP to motor oil will work well. Just put a couple drops on your clip and rub it in vigorously using firm pressure with a lint free cloth. This will help keep it looking it’s best cosmetically.

 

MOD4 1.75U

 

• .41″ OAL +/-.03″
• Width: .624″
• Fits over belts up to 1.75″ including thicker riggers belts.
• Features two inline slots to fit virtually any logical hole spacing used by holster makers while providing subtle ride height adjustment for the user.
• Inside dimensional tolerances: +/-.03″
• Just enough clearance to fit low profile Chicago Screw hardware in the top of the upper slot underneath the grab lip.
• Standard DMG/Cu finish: Color – DCC dark matte grey. Non reflective and resists corrosion very well.