T.Kell Multi-Clip

 Fits the same holes as your horizontal clip. You can already use the included horizontal clip for left and right handed cross draw, scout carry, IWB, deep carry static line and more. Now we've re-thought versatility in our new multi-clip. We wanted a do all, easy to setup clip that could be used in every carry setup you can think of using the same basic hardware. The multi-clip can be easily configured using the included hardware for left or right side vertical belt carry. It can be adjusted for height to carry lower or higher. Switch a couple of screws around and you have left or right handed tip up carry that fits the MOLLE loops on your plate vest. It fits all standard MOLLE setups on your go bag, mag pouches etc. Can be setup for inverted Left or right handed 6 o'clock belt  carry. We've tried to make it easy to carry your T.Kell Knife anywhere, in anyway.

Brand: Discreet Carry Concepts™
*Clips are sold individually. One each = one clip*

HLR 2.1u

For vertical IWB, MOLLE and Pocket carry

 

2.89" OAL +/-.03"

Width: .624"

Designed to be worn on a pocket or behind the belt and out of sight. Nothing to be seen extending below or over the belt.
Standard DMG/Cu finish: Color - DCC dark matte grey. Non reflective and resists corrosion very well.
Hardware included.
Care and maintenance: Our new finish does not need much attention. If any light scratches or wear marks develop, we recommend a quick buff with WD40, but anything from vegetable oil to mineral oil to CLP to motor oil will work well. Just put a couple drops on your clip and rub it in vigorously using firm pressure with a lint free cloth. This will help keep it looking it's best cosmetically.

 

Monoblock

For Horizontal (Cross-draw) 

Fits ALL T.Kell Sheaths

2.73" OAL
Fits over belts up to 1.5"
(2) .220"H x .300"W horizontal slotted mounting holes will work with spacing that is .750" - 1.00" on center.
Standard DMG/Cu finish: Color - DCC dark matte grey. Non reflective and resists corrosion very well
Works with or without a belt.
Hardware included. 

Standard DMG/Cu finish on all components: Color - DCC dark matte grey. Non reflective and resists corrosion very well
The Monoblock is engineered to be mounted directly to the Sheath body or other solid surface. Recommended hardware configuration from top to bottom: Screw, monoblock clip, rubber washer, body of the holster. The nut is placed on the inside. 

Care and maintenance: Our surface finish does not need much attention. If any light scratches or wear marks develop, we recommend a quick yet firm buff with WD40, but anything from vegetable oil to mineral oil to CLP to motor oil will work well. Just put a couple drops on your clip and rub it in vigorously using firm pressure with a lint free cloth. This will help keep it looking it's best cosmetically.

HLR mod-4 1.5

For vertical IWB,OWB, boot, pocket carry

3.41" OAL +/-.03"

Width: .624"

Fits over belts up to 1.5".

.205" round hole and horizontal slot spaced at .600"

Horizontal slot allows clip to be mounted on an angle 8° either direction.

Inside dimensional tolerances: +/-.03"

Standard DMG/Cu finish: Color - DCC dark matte grey. Non reflective and resists corrosion very well.